Bryce 9K-L Spezifikationen PDF herunterladen (Seite 21)

Operating the Printer

Recheck that all the necessary components of the printer are

installed.

Preparing

the Media

• Is the Wire Form Assembly installed?

• Is the Sliding Fence installed?

• Is the printer plugged into a power outlet?

• Does the printer have an Ink Jet Cartridge installed?

• Is the printer connected to the computer?

Now that all the parts of the printer are installed the printer

needs to be adjusted to work with the media. To avoid

problems of misfeeding and jams the media must also be made

ready for the printer.

Use the following steps to make the media ready for printing:

1. Take a manageable pile of media and while holding

them (as shown below in reference A), "fan" all sides

of the media to make sure that each piece of media is

free from one another.

Note: Maximum

thickness is 1/9” for

the 9KL.

2. Square the pile against the table top, assuring a square

pile on all sides. (Reference B) This will also allow

media to settle toward the bottom of a stuffed envelope

and will increase the feeding capabilities of the printer.

Fan All Sides of Media Square Media

Revision A 9K-L USERS MANUAL Section 4 -

P/N 90-00860-001

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 150 151

Keine Kommentare

Bryce 9K-L Spezifikationen Seite 21